connect@nelsonpaints.com +92 21 111 635 766

Semi Vinyl Emulsion

Semi Vinyl Emulsion

Product Description

Nelson Bold semi vinyl Emulsion is an interior quality wall paint based on Acrylic binder. It has very good opacity & durability. It is much-improved version of conventional distempers. While providing better finish and life, it is economically priced.

Design Usage

Nelson Bold semi vinyl Emulsion can be used on new & old interior surfaces such as plaster, concrete, hard board, and chipboard and brick walls.

Technical information

Theoretical Coverage

13 – 15 m2 per liter per coat (Actual Coverage is dependent on substrate condition, application  method, application condition and finishing appearance) 

Color

As per shade card

Volume Solid

40 % ± 2

Dry Film Thickness

30 ± 3 um per coat (based on substrate condition) 

Finish

Matt

Flash Point

None 

Drying Time

01 – 02 hour (Dependent on temperature and humidity) 

Recoat Interval

2 – 3 Hrs (Dependent on temperature and humidity)  

Application Method

Brush / Roller and spray, Dilute (by volume) the paint 30 – 50 % of fresh drinking water (This is recommended method of application Care should be taken to ensure an even application to avoid film defects)

Storage Instruction

Store in a cool shaded, well-ventilated dry area, protected from heat and direct sunlight. Container must be kept tightly closed. 

Packing

0.91 Liter, 3.64 Liters & 14.56 Liters drum.

 

Surface Preparation

The surface to be painted should be clean, dry free from all loose material like efflorescence and old Flaking paint, uneven areas should be filled with Nelson Exterior Wall Putty and leveled with emery paper before painting.

Condition during Application

The temperature of the substrate should not be less than 10oC and at least 3oC above the dew point of the air, temperature and relative humidity measured in the vicinity of the substrate.


Typical Paint System interior

Primer

Nelson Water based Bold Primer Sealer

1 Coat

Putty

Nelson Bold Wall Putty 

2 Coats

Finish

Nelson Bold Semi Vinyl Emulsion

3-4 Coats

 

Safety Precautions

  • Avoid contact with the skin and eyes. Wear suitable protective clothing such as goggles, dust mask and gloves. Use a barrier cream.
  • Ensure that there is adequate ventilation in the area where the product is being applied. Do not breathe vapors or spray.
  • This product is un-flammable but Keep away from sources of ignition and heat.
  • Paint should be stirred well before use. Replace lid of unused paint tin tightly.

Disclaimer

The information provided on this data sheet is not intended to be completed and is provided as general advice only. It is the responsibility of the user to ensure that the product is suitable for the purpose for which he wishes to use it. As we have no control over the treatment of the product, the standard of surface preparation of the substrate, or other factors affecting the use of this product, we are not responsible for its performance nor would we accept any liability whatsoever or howsoever arising from he use of this product unless specifically agreed to in writing by us. The information contained in this data sheet may be modified by us from time to time, and without notice, in the light of our experience and continuous product development.