connect@nelsonpaints.com +92 21 111 635 766
My Account

Matt Finish Enamel

Matt Finish Enamel

 

Product Description

Nelson Extra Matt Finish Enamel is based on special Alkyd Resin and provides good durability and smooth finish.

 

Design Usage

Nelson Extra matt finish enamel can be used on metal, wood and concrete surfaces of interiors.

 

 

Technical information

Theoretical Coverage

14-16 m2 per liter per coat (Actual Coverage is dependent on substrate condition, application  method, application condition and finishing appearance) 

Color

As per shade card

Volume Solid

48 % ± 2

Dry Film Thickness

30 ± 3 um per coat (based on substrate condition) 

Finish

Matt 

Flash Point

360C ± 2 

Drying Time

Touch Dry 2-3 hours (Dependent on temperature and humidity)

Hard dry 24 Hrs (Dependent on temperature and humidity)

Recoat Interval

10 – 12 Hrs (Dependent on temperature and humidity)  

Application Method

Brush / Roller and spray, Dilute (by volume) the paint 10 – 15 % of . Nelson ideal Turpentine (This is recommended method of application Care should be taken to ensure an even application to avoid film defects)

Storage Instruction

Store in a cool shaded, well-ventilated dry area, protected from heat and direct sunlight. Container must be kept tightly closed. 

Packing

0.91 Liter, 3.64 Liters & 14.56 Liters drum.

 

Surface Preparation

The surface to be painted should be clean, dry free from all loose material like efflorescence and old Flaking paint. Un even areas should be filled with Nelson Acrylic filling putty and leveled with emery paper before painting. Ferrous substrate should be sanded or wire-brushed to remove mill scale and rust. The scraped areas should be primed using Nelson Red oxide primer for wood apply nelson under coat.

Condition during Application

The temperature of the substrate should not be less then 100C and at least 30C above the dew point of the air, temperature and relative humidity measured in the vicinity of the substrate.

Typical Paint System interior

Primer

Nelson Extra Wall Primer Sealer (Dependent on surface conditions)

1-2 Coat

Finish

Nelson Extra Matt Finish Enamel

2-3 Coats

 

Safety Precautions

  • Avoid contact with the skin and eyes. Wear suitable protective clothing such as goggles, dust mask and gloves. Use a barrier cream
  • Ensure that there is adequate ventilation in the area where the product is being applied. Do not breathe vapors or spray.
  • This product is flammable, keep away from sources of ignition and heat.
  • Paint should be stirred well before use. Replace lid of unused paint tin tightly.

Disclaimer

The information provided on this data sheet is not intended to be completed and is provided as general advice only. It is the responsibility of the user to ensure that the product is suitable for the purpose for which he wishes to use it. As we have no control over the treatment of the product, the standard of surface preparation of the substrate, or other factors affecting the use of this product, we are not responsible for its performance nor would we accept any liability whatsoever or howsoever arising from the use of this product unless specifically agreed to in writing by us. The information contained in this data sheet may be modified by us from time to time, and without notice, in the light of our experience and continuous product development.