+92 21 111 635 766

Exclusive Emulsion

Exclusive Emulsion

Product Description

Nelson Exclusive Emulsion is high PVC Economical Wall Paint based on Acrylic binder which gives smooth and matt finish.

Design Usage

Nelson Exclusive Emulsion can be used on new & old interior surfaces such as Plaster, Concrete, Hard board, and Chipboard and brick walls. 



Technical information

Theoretical Coverage

08 – 10 m2 per liter per coat (Actual Coverage is dependent on substrate condition, application  method, application condition and finishing appearance) 


White, Off White, Ash White

Volume Solid

38 % ± 2

Dry Film Thickness

38 ± 3 um per coat (based on substrate condition) 



Flash Point


Drying Time

01 – 02 hour (Dependent on temperature and humidity) 

Recoat Interval

2 – 3 Hrs (Dependent on temperature and humidity)  

Application Method

Brush / Roller and spray, Dilute (by volume) the paint 30 – 50 % of fresh drinking water (This is recommended method of application Care should be taken to ensure an even application to avoid film defects)

Storage Instruction

Store in a cool shaded, well-ventilated dry area, protected from heat and direct sunlight. Container must be kept tightly closed. 


14.56 Liters drum


Surface Preparation

The surface to be painted should be clean, dry free from all loose material like efflorescence and old Flaking paint, uneven areas should be filled with Nelson Exclusive
Flat Putty and leveled with emery paper before painting.

Condition during Application

The temperature of the substrate should not be less then 100C and at least 30C above the dew point of the air, temperature and relative humidity measured in the vicinity of the substrate.

Typical Paint System interior


Nelson Exclusive Water Based Primer

1 Coat


Nelson Exclusive Flat Putty

2-3 Coats


Nelson Exclusive Emulsion

3-4 Coats


Safety Precautions

  • Avoid contact with the skin and eyes. Wear suitable protective clothing such as goggles, dust mask and gloves. Use a barrier cream
  • Ensure that there is adequate ventilation in the area where the product is being applied. Do not breathe vapors or spray.
  • This product is un-flammable but Keep away from sources of ignition and heat.
  • Paint should be stirred well before use. Replace lid of unused paint tin tightly.


The information provided on this data sheet is not intended to be completed and is provided as general advice only. It is the responsibility of the user to ensure that the product is suitable for the purpose for which he wishes to use it. As we have no control over the treatment of the product, the standard of surface preparation of the substrate, or other factors affecting the use of this product, we are not responsible for its performance nor would we accept any liability whatsoever or howsoever arising from the use of this product unless specifically agreed to in writing by us. The information contained in this data sheet may be modified by us from time to time, and without notice, in the light of our experience and continuous product development.