For Exterior of Boiler Paints

A single pack, air drying, anti corrosive coating. Formulated using high quality special grade inert bituminous

Design Usage

  • Surfaces in contact with fresh and salt water
  • Fully cured Boiler Paint A covers a range of 52C (125F) to 232C (450F)
  • Excellent resistance to corrosion
  • Can be applied directly to non blasted metal surface, if blasting isnt practical
  • Economical coating for structural steel works
  • Suitable for exteriors of boilers, condensers, chimneys, evaporators etc.
  • Relative humidity should not exceed 85% and substrate temperature should be more than 3C above Dew Point
  • Physical Data
    Recommended Application Data & Theoretical Coverage(m2/ltr.) by airless Gun
    Wet (µm) Dry (µm) m2/ltr.
    80 38 8 - 10
    Type Single Pack - Air Dr
    Volume Solids 47 ± 2%
    Flash Point 28 - 32oC
    Finish Matt
    Color 80
    Packing 4 Liters
    Ratio Not Applicable
  • Application Method
    Brush / Roller This is the recommended method of application. Minimum two coats must be applied for consistent performance. Do not apply a thick uneven coating
    Airless Spray Care should be taken that not to apply too heavy coats and: Tip Size:0.33~0.43 mm (0.013-0.017 in) Pressure: 1 10~150 Kg/cm2(1600-2100 psi
    Conventional Spray For air spray equipments maintain a pressure at: 2.8~3.5 Kg/cm2 (40-50 psi)
  • Drying / Curing Time
    Surface
    Temperature
    Touch Dry
    (Hrs.)
    Hard Dry (Hrs.) Minimum
    (Hrs.)
    Pot Life (Hrs.)
    15C 8 24 24 Not Applicable
    25C 7 22 22 Not Applicable
    35C 6 20 20 Not Applicable

  • Additional Information
    Thinner (Brush) Nelson Ind. Air Drying Thinner
    Cleaner Nelson Ind. Air Drying Thinner
    Storage Instruction Store in a cool shaded dry area
    Shelf Life As long as the container is kept firmly sealed & stored under normal conditions, the material can be
  • Surface Preparation

    The life-span and performance of this coating is directly related to the degree of surface preparation
    •Remove oil, grease contaminants by using solvent followed by SSPC SP-01
    •The surface must be clean and dry prior to coating
    •Surface should be free from loose mill scale

  • Product Use Restriction

    This product will not be cured below 4C